When adding new media, always remove all of the media from the input tray and straighten the stack of new media. See the start guide for more information about loading input trays. Make sure that the input trays are loaded properly and are not too full.Only print on media that is not wrinkled, folded, or damaged.Only print on media that meets HP specifications.To prevent a jam, see the following instructions: An error in the software program and a jam message on the printer control panel display indicate a media jam. Occasionally, media becomes jammed during a print job. It probably has the same caveat about double sided printing, though for me that's a non-issue: I found another solution that's even easier. Find the red/blue/black wire bundle coming down from the top cover - unplug that cable going into the circuit board.ĭone. Unscrew the 4 screws holding the cover on and remove it.4. The gray, steel box that has lots of wires going into it contains the main circuit board. Push those open and open the side - it's on a hinge in the back.3. If you open the front door of the printer where the toner goes, there's two gray plastic flanges. The "right side" if you're looking at it. Always unplug a printer if you're working on it. It probably has the same caveat about double sided printing, though for me that's a non-issue:ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |